A Valentine for a Baseball Fan

What kind of Valentine’s Day card do you give to a baseball fan during a time of COVID-19? A triple heart slider in their team’s colors.

This card is the fourth of a series of Split-Slider Slimlines.

Card base is cut from heavy black cardstock. It is a rectangle 8 5/8 inches x 7 inches and folded in half to form a 3 ½ inch x 8 5/8 inches card base. The slider arm and easel panel template was printed also on heavy black card stock.

Split-Slider: This split slider is based off Spellbinders Large Die of the Month for January 2021. The three mini easels were drawn and cut based off the three heart openings in the slimline die. (You can download a template for the horizontal split slider in the Materials Used section below.) The slider arm is horizontal rather than vertical as previous cards were. (Hint: Rectangular easels that will slide under the heart frames eliminate a catchpoint for the easel.)

You can glue the easel panel to the back of the lacy panel as long as you don’t glue the easel tab area at the bottom of the heart frames. Just put glue around the outer edge of the lacy panel.

Because the top lacy panel is adhered on three sides to the card base and needs to be raised, I used foam tape strips to raise the panel. (I like Stampin’ Up’s foam adhesive strips because they are precut and narrow enough to fit along the edge of the lacy panel.) Adhere the easel tabs to the slider arm before removing the backing paper of the foam tape.

You may have to help fold the easels into the fully opened position the first time to train them. Once satisfied with the slider/easels’ movement, remove panel backing tape paper and adhere to card base lining up the lacy panel with the top fold edge of the card base. (Note: The top edge of the slider arm (the pull bar) should jut out over the card base so that fingers can easily pinch the bar and pull up.)

Pull-Bar: The long pull bar or top edge of the slider arm is reinforced with a thick cardstock strip. Three yellow arrows are glued to the pull bar and a white dot for the place to hold the card when pulling up the slider arm. (For good CRX – I add a slip of paper to the card when mailing to show how to open the card. PDF of slip download is in Materials Used.)

Decorating the Easels: Because I had cut the lacy panel three times, I had plenty of the heart cut outs. I used three yellow hearts to form the easel bases that are folded at the tip of the heart when adhered to the slider easel. Three more yellow hearts are glued only at the rounded tops to the easel base hearts.

Using foam squares I adhered stamped baseball equipment to the yellow hearts and placed a bat under them.

Make sure you don’t glue anything that will impede the easels from moving.

The foiled “Happy Valentine’s Day” sentiment and stamped “Take me out to the ball game” are adhered to the inside of the card with double sided tape.

Thank you for reading this blog post. Please like and leave comments 😊

If you enjoy reading about the card I make, please follow ullysworld489442913.com.

Split-Slider Slimline Series:

Day 1 – Split Sea Slider

Day 2 – Cloud Dreams

Day 3 – Triple Hearts

Day 4 – A Valentine for a Baseball Fan

Materials Used:

Template